I'm not really sure if this is the right place for this post, so mods please move if I put it in the wrong forum
The problem is with a Harrison Alpha 1550 S.
Everything works fine, except for when cutting certain threads in 'alpha' mode.
After a few passes, I get this '410 servo alarm: z axis excess error'
(this happens even with no material)
From looking through the manual, this is caused by an excessive deviation from the expected position.
This is controlled by parameter 1829 (current value is 500)
When I go to system parameters, how do I change them? I've tried entering '600' and hitting 'input', but I get a message saying 'wrong mode'
How am I supposed to edit these values? Any help with properly resolving the issue would also be greatly appreciated
Thank you