Hi SM. Welcome to the Zone!
Stepper motor wiring to the BOB is always only 4 wires. You end up doubling 4 of the 8 wires from the motor. So we all use 4 conductor wire, or twin twisted pair shielded cable with a drain wire.
If you are not going to use more than 3.5A per motor, there's a whole bunch of motor wire sources in this link:
http://crevicereamer.com/Page__57.html
And here's some basic CNC info that might be helpful to you:
http://crevicereamer.com/Page_2.html
CR.
http://crevicereamer.com
Too many PMs. Email me to my name plus At A O L dot com.