I want to configure my controller to run Mach2 but I need a port pin
for "enable" on each axis. How do I connect these to MAch2 as their
pin configutration does not allow for this?
I want to configure my controller to run Mach2 but I need a port pin
for "enable" on each axis. How do I connect these to MAch2 as their
pin configutration does not allow for this?
Hi:
Mach2 has 6 enables, one for each axis. YOu simple turn on the enable 1 - Enable x and they will go active to enable each axis which is turned on in the config..
(Mach3 also has a current reduction pin you could use if required...)
www.gearotic.com
Art Fenerty