585,938 active members*
3,323 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Uncategorised CAM Discussion > It's Smaller Than It Should Be!!

Thread: It's Smaller Than It Should Be!!

Results 1 to 5 of 5
  1. 06-05-2005, 11:30 PM #1
    SIMONSIGNS
    SIMONSIGNS is offline Registered
    Join Date
    May 2005
    Posts
    37

    Exclamation It's Smaller Than It Should Be!!

    Hi I'm using Kellycam and drew up some text, sent it to the machine it comes out about 1 inch high, when I originally drew it at 12 inches high....... I guess its a servo motor setting somewhere? maybe someone smarter than me can point me in the right direction!....thanks!
    Reply With Quote Reply With Quote
  2. 06-06-2005, 01:29 AM #2
    abasir
    abasir is offline Registered
    Join Date
    Apr 2003
    Posts
    361
    Go to Option > Table Setup and make sure it match your actual setup
    Attached Thumbnails Attached Thumbnails KCAM Setup.jpg  
    Stupid questions make me smarter...
    See how smart I've become at www.9w2bsr.com ;-P
    Reply With Quote Reply With Quote
  3. 06-06-2005, 08:05 AM #3
    SIMONSIGNS
    SIMONSIGNS is offline Registered
    Join Date
    May 2005
    Posts
    37
    thanks for your help.......
    Reply With Quote Reply With Quote
  4. 06-06-2005, 10:18 AM #4
    ynneb
    ynneb is offline Community Moderator
    Join Date
    Feb 2004
    Posts
    2337
    It's Smaller Than It Should Be!!
    Try Viagra.
    Being outside the square !!!
    Reply With Quote Reply With Quote
  5. 06-06-2005, 11:32 AM #5
    cbass
    cbass is offline Registered
    Join Date
    May 2004
    Posts
    290
    Quote Originally Posted by ynneb
    Try Viagra.


    Maybe it was the cold water
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Smaller Spindles?
    By spoiledbrat in forum Commercial CNC Wood Routers
    Replies: 6
    Last Post: 03-25-2006, 05:53 AM
  2. Anyone hazzard a guess at the VA rating of this transformer.
    By MrBean in forum CNC Machine Related Electronics
    Replies: 4
    Last Post: 02-12-2005, 01:03 AM
  3. How to weld plate to tube at 90 degrees?
    By coolman in forum Welding Brazing Soldering Sealing
    Replies: 12
    Last Post: 12-23-2004, 09:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules