[tbilecen]

Hi

i have HARTFORD OMNIS 1020 with Mitsubishi M65.

My problem is about tool change.

i have tried

M6 T**
T** M6

both combinations directly act like i use only M6

to get the right tool, i have to write T** (tool number) and M6 at seperate lines.

when i do this, machine stands still until next tool gets prepared.

is there any parameter setting or G-Code system to get ready my next tool while machining continue?

[ou812]

We have Mits horizontals with 520 control. We have to run our code like this

T1 (WORKING TOOL)
T2 M6 (T2 PRECALL NEXT TOOL)
.
.
.
.

It was pretty annoying it will alarm out if you call the tool already in the spindle.

OU812