[driftbuster50]

i have a puma 160 with a iseries control. i accidentially deleted my program today and unfortunaly the rs232 isnt working on the lathe. i was wondering if there is anyway to look back at the deleted history and recover lost programming. i hope there is some good feed back this will take me hours to re-program.
thanks
craig

[CNCRim]

Bad news, I don't think you can. Maybe in the future you can, like Mazak it has PC base then you can get lucky otherwise.

i have a puma 160 with a iseries control. i accidentially deleted my program today and unfortunaly the rs232 isnt working on the lathe. i was wondering if there is anyway to look back at the deleted history and recover lost programming. i hope there is some good back this will take me hours to re-program.
thanks
craig

[dcoupar]

No, once you've deleted a program, it's gone. You might want to get the RS-232 working.