im trying to take a flat part and pick areas on the part where i want it to bend in the sheet metal part creator. is this possible? can you just draw a flat tab and the pick bend line points?
Thread: sheet metal part problems
Results 1 to 1 of 1
-
08-22-2010, 12:15 AM #1
Registered
- Join Date
- Jan 2004
- Posts
- 55
sheet metal part problems
CHADWIGGAN
Reply With QuoteSimilar Threads
-
Sheet metal help!
By revwarguy in forum MetalWork DiscussionReplies: 10Last Post: 07-04-2010, 12:29 AM -
nx-sheet metal
By sk96_me45 in forum UG NXReplies: 0Last Post: 04-30-2010, 05:58 AM -
Turning tube into sheet metal part?
By bearracecars in forum SolidworksReplies: 6Last Post: 08-14-2009, 04:36 AM -
sheet metal spining problems
By fsa in forum Bending, Forging, Extrusion...Replies: 2Last Post: 02-07-2008, 02:05 PM -
What is best for sheet metal part modeling?
By REVCAM_Bob in forum Uncategorised CAM DiscussionReplies: 4Last Post: 01-25-2008, 06:05 PM
Posting Permissions
