585,931 active members*
3,802 visitors online*
Register for free
Login

Thread: srv400 board

Results 1 to 2 of 2
  1. 09-08-2010, 08:19 PM #1
    advt001
    advt001 is offline Registered
    Join Date
    Dec 2007
    Posts
    159

    srv400 board

    I have 2 -3 axis H20T43-SRV400 boards.Is it possible to make the 4 axis board with the electronics I have on hand?
    Reply With Quote Reply With Quote
  2. 09-08-2010, 09:15 PM #2
    Montabelli
    Montabelli is offline Registered
    Join Date
    May 2009
    Posts
    281
    yes and no. you have isa cards which should work, on the card there are 3 large ic chips and one empty socket all you need is one more chip and you can controle one more axis, if you have another amplifier card to power the servo. as well as the aditional motor cables etc.

    if you have a chip puller you can remove one chip from one board and add it to the other. watch out for static and bent pins.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Need Help c2 sieg mini lathe old circuit board to new board conversion
    By scottcmb in forum Benchtop Machines
    Replies: 1
    Last Post: 06-01-2010, 05:31 AM
  2. I only need the board
    By homsar66 in forum Xylotex
    Replies: 0
    Last Post: 02-11-2010, 08:34 PM
  3. How to connect ELM Board and OSMC Board ?
    By bigeye3107 in forum Open Source Controller Boards
    Replies: 2
    Last Post: 06-16-2008, 12:26 PM
  4. Breakout board, Relays on board?
    By Cooper in forum Open Source Controller Boards
    Replies: 11
    Last Post: 06-10-2007, 01:55 AM
  5. Can I hook up a 3-axis board to a 1-axis board ?
    By Redline in forum Xylotex
    Replies: 7
    Last Post: 02-10-2007, 04:45 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules