Is there anyone in the phoenix area who has good knowledge of mach3, and would be willing to help me out with getting a cnc router up and running? I have redone the electronics. The new set up is a computer w/XP PRO is a PMDX-132 and I have spend a great amount of time with tech support for the PMDX board who is not sure why I am not getting the inputs from parallel port LP1. He was not real familiar with Mach3, and had suggested to find someone thru this site.
I would really appreciate any help I can get!
Glen
Results 1 to 2 of 2
-
09-24-2010, 02:52 PM #1
Registered
- Join Date
- Jun 2005
- Posts
- 2
need help with mach3 in phoenix,az to get a router running
-
09-25-2010, 02:13 AM #2
Registered
- Join Date
- Feb 2005
- Posts
- 117
mach3 setup
I would suggest going on the the mach3 site on visiting their section on online tutorial. Go thru the videos several times and then revisit your setup with regards to configuration and diagnostics. Been there and done it several times.
JohnD.,
Reply With QuoteSimilar Threads
-
Running Mach3 with a Step four router
By B-Sure in forum Mach Software (ArtSoft software)Replies: 7Last Post: 05-29-2022, 04:41 PM -
1995 Phoenix router
By moxbig72 in forum Community Club HouseReplies: 0Last Post: 05-25-2010, 07:02 PM -
Phoenix Router / engraver
By beamsjr in forum Wood Lathes / MillsReplies: 2Last Post: 05-29-2009, 04:16 PM -
Phoenix router retrofit
By diemaker in forum Commercial CNC Wood RoutersReplies: 6Last Post: 03-09-2009, 03:04 AM -
Mach3...FET3...Phoenix Router
By Ric_A in forum Machines running Mach SoftwareReplies: 0Last Post: 06-03-2006, 06:19 AM
Posting Permissions
