Hi Guys.

I bought an old Roboform 200 and the digital power supply. a Weir SMM 200 NT, is dead. Does anyone know what the supplied amperage's are for each of the output voltages: +5VDC, +12VDC, and -15VDC?

This brings up another issue. The Weir power supply provides -15VDC and routes it to a terminal block that is labeled -12VDC. Is it really -15VDC or -12VDC? If anyone could measure the voltage at the -12VDC terminal block relative to chassis ground (or the O with a slash through it on the terminal block). The terminal block is located right below the Weir digital power supply.

When I say "digital power supply" I mean the power supply that powers the back plane of the computer card file.

Thank you for all your help.

Best Regards,

Paul Hoffman