I have a desktop mill that needs a new driver board.
I am looking at the G540, but have some questions with the current PSU and steppers.
Motors: (4) LIN 4218l-01-10 (2A/Phase 2.6mH/Phase)
Note: X-Axis requires 2 motors for a total of 4 motors.
PSU: MEAN WELL PSP-600-27 (27V 22Amp)
Is the current PSU too much for the steppers/g540?
Any reservations against this setup? Anything is replaceable, however the Nema 17 size must remain the same.