Originally Posted by
davidperry3
I made a Cyllinder anchored it and then drew a cap on one end with a boss and a tab. Then I drew a second cap on the other end with the same features except opposite. When I saved that last part it dissapeard and reappeared as a mirror image if itself on the other end! When I open this part in its own window it is reversed there as well WTF!
Have you contacted Alibre Tech Support about this issue??
It's always best to report these events so a solution can be found ASAP
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com