[davidponte]

I am looking for the tail stock for the DYNA MYTE 3000 lathe. I hoped some one that was parting out a 3000 thinking of me if they see this post or pass the word around.

DAVID PONTES

[email protected]

[2ferrous]

Could you post some dimensions and the center height?
Never know what I might find when I searching through the spare parts section of used machinery dealers.

Timothy

[Fastest1]

David have you joined the Dyna group on Yahoo?

[davidponte]

Hi,

I am on yahoo Groups, but have more luck on this sight for spare parts.

david pontes

[3illmesmart]

For reference, my tailstock base is 4" wide, 6" long and the height is 4.375"

[Fastest1]

I went and double checked mine after you put this info in. The 4.375 is the distance from the base of the tailstock casting to the center of the bore. The overall height is 5.375. Anyone else? My tailstock was purchased seperately.

For reference, my tailstock base is 4" wide, 6" long and the height is 4.375"

[3illmesmart]

I went and double checked mine after you put this info in. The 4.375 is the distance from the base of the tailstock casting to the center of the bore. The overall height is 5.375. Anyone else? My tailstock was purchased seperately.

You are correct, I failed to specify the dimension was to the tailstock center.