585,741 active members*
4,992 visitors online*
Register for free
Login

Thread: GibbsCam 5 axis

Results 1 to 2 of 2
  1. 07-10-2003, 08:06 PM #1
    cadman
    cadman is offline Registered
    Join Date
    Jun 2003
    Posts
    513

    GibbsCam 5 axis

    Anyone know anything about a module from Productec called ProAXYZ ? Its a module for 5 axis simultaneous machining developed for GibbsCam. I'm interested in hearing from anyone who has actually used it.

    Thanks
    Reply With Quote Reply With Quote
  2. 07-13-2003, 03:05 AM #2
    Turbine
    Turbine is offline Registered
    Join Date
    Mar 2003
    Posts
    115
    I have been doing some investigating recently, but have not used it. GibbsGod can tell you more. Also check out the last couple posts in this thread.
    http://www.cnczone.com/showthread.ph...hlight=Proaxyz
    I will PM you contact information for this.
    "The source of expertise is not in the memorization of the minute details of a subject but in the thorough understanding of the fundamental concepts on which it is based." --author unknown
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 4020 4th axis problems
    By little bubba in forum Fadal
    Replies: 3
    Last Post: 06-14-2005, 03:08 AM
  2. No Encoder Counts On X Axis. Y=OK
    By murphy625 in forum CamSoft Products
    Replies: 5
    Last Post: 03-09-2005, 03:20 AM
  3. 2 axis to 3 axis conversion
    By drembedded in forum Bridgeport / Hardinge Mills
    Replies: 10
    Last Post: 10-27-2004, 05:32 PM
  4. Gantry/two motors per axis...how to configure
    By chozo in forum DIY CNC Router Table Machines
    Replies: 8
    Last Post: 08-28-2004, 02:50 AM
  5. My Lathe project; might CNC it one day
    By Stevie in forum Uncategorised MetalWorking Machines
    Replies: 86
    Last Post: 06-22-2004, 02:27 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules