Hello there'
We have two DSG lathes with Fanuc ot controllers. Recently one had memory deleted (idiot operator holding buttons on start up). We got cnc back up running and copied parameters / macros back in from a back-up. After some setting up machine now runs ok. What we don't have is the time (i.e. 12 hour clock) displayed on the screen (usually appears bottom right corner above soft keys display). It doesn't affect cnc running but operators moan display is not right. I have checked against other machine and all appears the same. I have installation and parameter manual and can find no reference.
Thread: Fanuc ot display
Results 1 to 2 of 2
-
12-09-2010, 03:52 PM #1
Registered
- Join Date
- Dec 2010
- Posts
- 0
Fanuc ot display
-
12-09-2010, 05:30 PM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24220
PM sent.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With Quote
Similar Threads
-
Fanuc Oi-MB Relative display
By zooloader in forum FanucReplies: 7Last Post: 10-28-2021, 01:57 AM -
Fanuc 10M, EMG Display On, EMG Button OK, Rev 6-29
By JimBoyce in forum FanucReplies: 2Last Post: 02-24-2011, 08:22 PM -
Fanuc O-MD prog ck display
By yoshi900 in forum FanucReplies: 3Last Post: 10-15-2008, 11:35 AM -
Fanuc 0i-TC Display Parameter
By Hoonie in forum FanucReplies: 5Last Post: 05-20-2008, 07:44 PM -
Position Display on fanuc 6m
By fredf1 in forum FanucReplies: 1Last Post: 10-22-2005, 10:08 AM
Posting Permissions
