I have acquired an old CNC machine which was built with 5 phase stepper motors. As I attempt to retrofit the machine with newer steppers of the bipolar fashion, I noticed the motor sizes are of course not compatible. The center locking wheel on the 5 phase stepper is 36 mm in diameter, whereas the typical NEMA23 stepper is 1.5" which is close to 38 mm.
Is there a bipolar stepper out there with the beveled round center at 36 mm, or will I need to build some form of an interface plate? That would be easy if I had a working CNC machine ;-) The chicken and the egg...