These cuts were done with a TD A120 air plasma: 120 amp, 28 IPM, .19 cut height.
Disregarding the pierce divot could I expect comparable or better cut quality with a Hypertherm 1650? I would like to see less bevel but realize that may be asking a lot for air plasma.
In reading posts here and talking to others using Hypertherm machines I am not convinced that Thermal Dynamics consumable life is as good as they claim.
I would be interested to see others cuts on 3/4 a36 plate as a comparison if some of you have them.
The Thermal folks have been good....... But I am questioning if it may be time to switch!
Thanks for any input, Steve