585,743 active members*
4,948 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Mori Seiki Machines > Mori Seiki Mills > Spindle Assembly Drawing for Mori VMC SV500/40

Thread: Spindle Assembly Drawing for Mori VMC SV500/40

Results 1 to 2 of 2
  1. 12-17-2010, 09:27 PM #1
    shivisood_24
    shivisood_24 is offline Registered
    Join Date
    May 2010
    Posts
    0

    Post Spindle Assembly Drawing for Mori VMC SV500/40

    Hi all,

    Looking for the spindle assembly drawing for Mori SV500/40.

    Actually the spindle is not holding the tool and seems like the collet is not opening.
    Need the spindle assembly drawing to disassemble it recity.
    Can any body help.

    Regards,
    Shivek Sood
    Reply With Quote Reply With Quote
  2. 12-18-2010, 01:56 AM #2
    underthetire
    underthetire is offline Gold Member
    Join Date
    Feb 2009
    Posts
    6028
    If the collet is not opening, most likely need to bleed the Tool unclamp Cylinder. It's a air over oil system that is closed loop during automatic tool change. If the tool is pulling out, then you need to change the springs/collet. The unclamp cylinder has a small black block sticking out, that has a small tube pressed in and a socket head screw with a lock nut. Put the machine in MDI mode, then open the valve till all the air comes out. Tighten the cap screw (closing the valve) then go to manual and try. You may have to do it several times.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Arrow 500 need drawing for drawbar assembly
    By scudzuki in forum Cincinnati CNC
    Replies: 4
    Last Post: 08-22-2016, 08:51 PM
  2. Mori SV500-Need to find skip X bit
    By ASIGuy in forum Mori Seiki Mills
    Replies: 6
    Last Post: 03-09-2009, 02:13 PM
  3. Boss R2E3 - need drawing of head assembly
    By Scott Kelley in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 09-08-2008, 09:31 PM
  4. information needed on spindle assembly
    By intelsingh in forum MetalWork Discussion
    Replies: 3
    Last Post: 02-23-2005, 03:49 PM
  5. SV500 servo drives
    By eman5oh in forum Servo Motors / Drives
    Replies: 5
    Last Post: 02-14-2005, 10:15 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules