585,727 active members*
4,205 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Okuma > Tuning Okuma LC-40 axis drive board 3000 control

Thread: Tuning Okuma LC-40 axis drive board 3000 control

Results 1 to 2 of 2
  1. 01-07-2011, 09:18 PM #1
    stude8
    stude8 is offline Registered
    Join Date
    Mar 2005
    Posts
    110

    Tuning Okuma LC-40 axis drive board 3000 control

    Is there any documentation available for tuning of the axis boards? Our Z axis overshoots and also alarms with a 1013 alarm. There are a number of pots, but I'm not comfortable just adjusting the gain without knowing what I'm doing. Thanks in advance
    Reply With Quote Reply With Quote
  2. 01-15-2011, 01:03 PM #2
    blaineh
    blaineh is offline Registered
    Join Date
    Aug 2010
    Posts
    0

    lc40 overshoot

    There is a adjustment proceedure techs had, but these were intended for when these boards were replaced. If the problem cropped up, I doubt it could be adjusted out. Was this machine on your floor when it functioned correctly?
    We have these boards and encoders, ect, if you need them.
    We can also dig up the adjustment proceedure, for replacement.
    Contact Blaine at [email protected]
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. osp 3000 for an lc20 okuma
    By gmsmachinists in forum Okuma
    Replies: 13
    Last Post: 11-25-2014, 02:20 PM
  2. Problem with OSP 3000 of Okuma LC10
    By Dynamometer in forum Controller & Computer Solutions
    Replies: 4
    Last Post: 10-23-2014, 07:20 PM
  3. Okuma OSP 3000 tape reader
    By hsimola in forum Okuma
    Replies: 2
    Last Post: 04-01-2008, 04:37 AM
  4. Bosch Axis Drive Board Z15-1-240V
    By RMARCH in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 08-15-2007, 06:35 PM
  5. OSP 3000 okuma code.
    By Tonenc in forum G-Code Programing
    Replies: 0
    Last Post: 04-24-2006, 08:28 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules