Hello add this happen back in 2009 and it went away
and now its back and need to find out what my be the cause of it
its kind of funny how this happens but I can make it happen every time i do this
step one open a program and try to use the auto set for the speeds and feeds
hit it once and all is fine go back and try it again and Wham out goes the control and the screen show what is in the first pic Parity Error
then when i restart it as error 2nd pic 411 Power off during program edit
pic 3 is in program at the point before the control shuts off
pic 4 is the auto set button for the speed and feeds
pic 5 is hardware alarm screen
pic 6 is alarm messages
and if the machine is not at home 1 it will not find zero again in less you
manually move the ball screws to the limit switch in x y & z with the power off
because the end coder thinks it at zero
is there away to move the servo past zero as where the encoder thinks it is at. manually
thanks for your time
speed