585,898 active members*
4,928 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Mastercam > Toolchange problem

Thread: Toolchange problem

Results 1 to 3 of 3
  1. 01-15-2011, 11:04 PM #1
    armcoracing
    armcoracing is offline Registered
    Join Date
    Nov 2010
    Posts
    10

    Toolchange problem

    I want to do a tool call for different ops when im using the same tool,i have 4 different ops one after the other using the same tool but i want to be able to go to each op when seeing the job through,but in mastercam mill 9 it wont do a tool call at each op,it see's it as a null toolchange,ive tried to adjust settings in the post but have had no luck,can anyone advise what to do thx
    Reply With Quote Reply With Quote
  2. 01-16-2011, 09:45 AM #2
    jeffrey001
    jeffrey001 is offline Banned
    Join Date
    May 2008
    Posts
    667
    On the tool dialog box where you input tool number, feed, rpm etc, just check FORCE TOOL CHANGE just under the plunge rate input box.


    Hope this help.

    Jeff
    Reply With Quote Reply With Quote
  3. 01-16-2011, 10:28 AM #3
    armcoracing
    armcoracing is offline Registered
    Join Date
    Nov 2010
    Posts
    10
    Many thanks Jeff,ive beem messin about with that for days, i knew i could rely on someone on cnc zone.
    Regards Adrian
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. HAAS VF0 toolchange problem
    By lapokerplayer in forum Haas Mills
    Replies: 3
    Last Post: 05-25-2022, 08:36 PM
  2. Toolchange problem, Okuma MX-55VB OSP U-100M
    By Adaware in forum Okuma
    Replies: 7
    Last Post: 01-04-2018, 09:22 PM
  3. Toolchange
    By zooloader in forum Okuma
    Replies: 6
    Last Post: 11-04-2010, 08:48 PM
  4. MV-55 Toolchange problem
    By Basspilot in forum Mori Seiki Mills
    Replies: 4
    Last Post: 04-03-2009, 09:58 AM
  5. Problem with toolchange in Mazak Quickturn nexus II
    By Legenden in forum Mazak, Mitsubishi, Mazatrol
    Replies: 2
    Last Post: 03-31-2009, 08:36 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules