[panozeng]

I took a fully functional Hybrid D11 (aka Picopath) system off my Advance Cutting Systems (Koike built) plasma table to go to Mach3 control. Controller, amplifier/driver box, and servo motors with encoders are all sitting in a pile near the machine taking up space. If anyone needs parts or the entire system this would be a good starting place.

[Roy's cnc]

Yes , Might be interested in your spares. Give me a call 601-319-3448. We have a D-11 that we are currently using. Which torch height control are you using?

[jdp]

Did you end up selling the d11 controller that you had listed ?

[panozeng]

Still have it - what are you in need of?

[jdp]

Still have it - what are you in need of?

We just had to have the factory quick ship a circuit board for the controller but thought if yours is the same as what we have that we might be interested in buying some or all of the parts. If you want to give me a call at 515-299-4132 we could talk about it.

Regards, John Pulley

[apk2533]

Do you still have these parts? I am need of them if you do. Thanks

[ivan4144]

do you still have the picopath d11 control and motors available?
if you do call me 519-699-4144 8 am to 8 pm
thanks ivan martin

[panozeng]

I still have the parts - just haven been on here in forever.

[AULLC]

I still have the parts - just haven been on here in forever.

Still have the controller? I am in need of one. call me 218-849-7333