I need help!!! while doing DNC in sinumerik
i am not getting last 10 lines of program
I need help!!! while doing DNC in sinumerik
i am not getting last 10 lines of program
Is there M30 by mistake ?
M30 must appear only at the end.
No, and if at all M30 is there it will be followed by Subprograms and subprograms will be stored automatically.
This machine was relocated recently and was working fine in the prev location. I have tried reducing the baudrate but no use!!!
And don't doubt about the memory, there is lots of space.
It solved at last but i dont know whether this is the correct method or not I put an EOT in controller and the DNC software and is working fine now.
anyway thanx digitech
One of my friends has Mazak VMC Mazatrol Control M-1 Make: 1982
Does any one know, if this control has a drip feed facility ?
If yes, how to activate it ?