Hi,
I have a problem with a chinese made milling center Gold Sun GS1060.
The machine was made in China but has a Mitsubishi Meldas 60S Series controller and there is no information available.
I've found handbooks of the Mitsubishi controller, but nothing about the GS1060 machine.
The problem is:
When I send the command M06, in MDI mode, to change tool, the magazine, becames jammed and the machine stops.
It seems the Z position of spindle is not aligned with the tool magazine.
Is there any procedure to calibrate the Z position of the spindle relative to tool magazine?
Thanks,
Roger