585,597 active members*
3,159 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > ArtCam Pro > 3D Cutting with Artcam Express and AXYZ Router

Thread: 3D Cutting with Artcam Express and AXYZ Router

Results 1 to 4 of 4
  1. 02-07-2011, 05:34 AM #1
    CNCRam
    CNCRam is offline Registered
    Join Date
    Feb 2011
    Posts
    0

    Smile 3D Cutting with Artcam Express and AXYZ Router

    I just had our AXYZ router upgraded and with it received Artcam Express 10. Within the menus are some relief cutting shapes already designed (horses, dogs, etc) I go through the steps and have done some research and when the machine cuts it only makes a shallow flat relief and then returns to the start position and the spindle stops. A good recommendation on how to cut reliefs for beginners would really be appreciated.
    Reply With Quote Reply With Quote
  2. 02-17-2011, 10:39 AM #2
    Monkey_Nuts
    Monkey_Nuts is offline Registered
    Join Date
    Feb 2011
    Posts
    0
    You may have more luck posting on the ArtCAM forum:

    ArtCAM Forum • Index page

    Sure there is a section for express users
    Reply With Quote Reply With Quote
  3. 02-17-2011, 03:18 PM #3
    CNCRam
    CNCRam is offline Registered
    Join Date
    Feb 2011
    Posts
    0
    Thanks Monkey Nuts. I will give that a try.
    Reply With Quote Reply With Quote
  4. 05-06-2011, 09:49 AM #4
    Monkey_Nuts
    Monkey_Nuts is offline Registered
    Join Date
    Feb 2011
    Posts
    0
    no problem :banana:
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. ArtCAM Express
    By warren01 in forum Uncategorised CAM Discussion
    Replies: 0
    Last Post: 01-19-2010, 08:57 PM
  2. Recently purchased ArtCAM Express
    By artcamguru in forum ArtCam Pro
    Replies: 0
    Last Post: 11-26-2008, 04:28 PM
  3. Artcam Express
    By lovebugjunkie in forum ArtCam Pro
    Replies: 0
    Last Post: 07-29-2008, 06:38 PM
  4. Anyone know about ArtCAM Express
    By RHRocker in forum Uncategorised CAM Discussion
    Replies: 5
    Last Post: 02-22-2008, 06:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules