We are having Mitsu Seiki VMC with Fanuc 6M Control
Machine Absolute Value getting reset during reset the Program in Auto mode. it seems to be a Parameter Problem. any body can help us.
Thread: Absolute position getting reset
Results 1 to 3 of 3
-
03-04-2011, 05:51 PM #1
Registered
- Join Date
- Apr 2007
- Posts
- 128
Absolute position getting reset
L. Sakthivel
Email:[email protected], website:www.premierengrs.com
-
03-05-2011, 06:46 PM #2
Gold Member
- Join Date
- Jun 2008
- Posts
- 1511
Post your code where it keeps getting rest so we can take a look at it. There can be many things in the code causing this. Most are setup to reset when G28 is programmed or it could be done in a sub with a tool call. These are just a few exapmles.
Stevo
-
03-06-2011, 06:54 AM #3
Registered
- Join Date
- Aug 2008
- Posts
- 151
Manual Absolute
L. Sakthivel,
I would check the state of the "Manual Absolute" function. It is usually, but not always, controlled by a toggle switch. In one position "Reset" will change the Absolute position. In the other position, it will not.
Many many people have scrapped parts or crashed their machines by having this switch in the wrong position.
Warren
Uptime Electronics, Inc.
Reply With QuoteSimilar Threads
-
Absolute cords reset in handle mode
By quasarix in forum FanucReplies: 15Last Post: 05-15-2019, 11:25 AM -
Absolute position data lost ATC Matrix VCN 510C
By nexuss in forum Mazak, Mitsubishi, MazatrolReplies: 2Last Post: 11-19-2010, 05:37 PM -
0-MD Machine loses absolute coord with reset
By ILCORKILL in forum FanucReplies: 6Last Post: 02-25-2009, 06:41 PM -
Fanuc 11M Absolute position probs
By trotsky in forum FanucReplies: 0Last Post: 11-05-2007, 08:29 PM -
Absolute position PROBLEM
By Darkos in forum FanucReplies: 2Last Post: 10-18-2006, 09:26 PM
Posting Permissions
