Hello.
I run a fadal 2016L at my work. And the fadal got a button called "Slide Hold".
Can i fix my emergency stop in mach3 (im using gecko 540) like a "Slide Hold" button so i dont missing any step when i use it?
Greetings from Robert.
Hello.
I run a fadal 2016L at my work. And the fadal got a button called "Slide Hold".
Can i fix my emergency stop in mach3 (im using gecko 540) like a "Slide Hold" button so i dont missing any step when i use it?
Greetings from Robert.
My second homebuilt cnc machine cnczone.com/forums/norwegian_club_house/123977-ombygget_cnc_-_gecko_540_a.html
No. Use the Feedhold instead.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
yeah, but the feedhold is not turning "on" before the g code line is finish? so if i run x100mm with a feed 60mm/min. it goes to x100, THEN stop. Understand?
Greetings from Robert.
My second homebuilt cnc machine cnczone.com/forums/norwegian_club_house/123977-ombygget_cnc_-_gecko_540_a.html
Try checking "No FRO on Que" in General Config.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)