585,752 active members*
3,831 visitors online*
Register for free
Login

Thread: Hypertherm Command THC

Results 1 to 2 of 2
  1. 06-24-2011, 08:54 PM #1
    Greg721
    Greg721 is offline Registered
    Join Date
    Feb 2011
    Posts
    0

    Hypertherm Command THC

    I have been having problems with my height controller sticking in the down position. I have replaced the linear motion bearings and rails, the band seal and rollers. After doing this it ran good for about a day and begun sticking again.

    Any suggestions?

    Thanks,
    Greg
    Reply With Quote Reply With Quote
  2. 06-28-2011, 06:06 PM #2
    jimcolt's Avatar
    jimcolt
    jimcolt is offline Registered
    Join Date
    Jan 2008
    Posts
    2247
    Best bet is to contact Hypertherm tech service....they are free, very easy to work with, and they spend all of their days helping people with Hyperthem products.

    HySupport
    Technical Service
    [email protected]
    800-643-9878 Tel - Toll Free in USA
    and Canada


    Jim Colt
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Problems with Hypertherm command THC
    By kjferg in forum Hypertherm Plasma
    Replies: 19
    Last Post: 08-24-2010, 01:45 AM
  2. G54 command
    By bfedger in forum G-Code Programing
    Replies: 20
    Last Post: 04-17-2010, 06:51 AM
  3. G68 command
    By Ashish B in forum CNC Machining Centers
    Replies: 6
    Last Post: 01-23-2010, 05:25 AM
  4. M01 command
    By slideleft in forum Haas Mills
    Replies: 4
    Last Post: 11-20-2008, 10:01 PM
  5. what is the same command?
    By hop in forum G-Code Programing
    Replies: 0
    Last Post: 06-20-2006, 11:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules