Ok, so on a Lathe I got with a Fanuc 10t on it. The parameters were lost. I got parameters from a so called identical machine, and loaded those, Here is the problem:
When I hit turret index, it indexes Two positions. I belive this is because there is an orfice in the solinoid, and it is going so fast that it cannot catch on the slow down switch? I belive someone took the restrictor out of this orfice?
Also, whe I command a T0100, it will just advance one position, no matter which tool it is on. So you can just keep comanding T0100 and it will just keep advancing one position.
But if I comman a T0200 or any other number, T0300, T0100, etc. It will just keep spinning the turret, and never stop untill I hit the E stop.
I have checked in the PCDGN page, and the manual shows that it is on x000, and the numbers do change in those bits, so I know the encoder on the back of the turret is working.
I belive I have a parameter wrong. Does anyone know which parameters to look at?