Originally Posted by
thor2k
I am overwhelmed by the array of resources and talent here, so I respectfully submit my general request here, hoping that someone will guide me to the right spot.
Generally, I need:
- scanning
- machining
- in or near Jacksonville, FL
The existing part(s) are small (40cm x 20cm x 20cm) and "jewelry-level"
precision is necessary. The scan file needs to be "tweaked" with corrections
and design modifications.
The new parts need to be machined from a variety of stock.
We need one initial prototype (then another?, then another?) then
production runs of 100 assemblies (300 pieces) in each of copper, aluminum,
silver and stainless steel.
I would prefer the shop be nearby as it might facilitate the turnaround times,
but I am not married to it. Mostly, we need a responsive, "hands-on" facility,
perhaps even a hobbyist with the skills and interest in handling such a
short-run production series, but with the scanner and software skills on the
front end.
ALL suggestions, leads, guidance will be appreciated.