I'm trying to produce 3 rows of 10 off Ø8mm holes on each row around a circumference of a solid model. Two rows being inline whilst the middle row being 1/2 way between the other 2.
Does anyone know which is the best way to achieve this?
Firstly I drew the pattern on a plane then wrapped it around the circumference but was then unable to 'Extrude Cut' the holes through, whilst trying to pick up on the sketched circles (holes)
Secondly instead of sketching the circles I created points, which I hoped I could then select the 'Extrude Cut' to locate on each point.
However, I was unable to Wrap the points around a circumference.
Any ideas anyone?