anyone have a good set up for cutting duct thin galvy 24 ,26 ga. amps, ipm, sp, etc. also could use some help with vertex slowdown, i run mine at 50/50 but dont really understand the exact mechanics of it of it.
Results 1 to 3 of 3
-
05-06-2011, 12:10 PM #1
Registered
- Join Date
- Apr 2011
- Posts
- 5
dynatorch set up for duct work thin ga
-
06-23-2011, 12:05 PM #2
Registered
- Join Date
- Dec 2007
- Posts
- 41
The settings I use for ductwork are arc voltage 85 and speed 200ipm. I'm using a powermax 1000 with finecut consumables with the plasma set at 30amps. These setting are best for 26g to 20g sheetmetal. Running great for about 4 yrs.
-
06-23-2011, 09:58 PM #3
Registered
- Join Date
- Apr 2011
- Posts
- 5
cant seem to get up to 200ipm, anything after 180 the corners get sloppy like it cant handle the speed and you hear the gantry banging a bit. I think the corner slowdown is not set right, have it 50degree/65% with acceleration at 6.
Reply With QuoteSimilar Threads
-
DIN 3 Rail & Wire Duct Screw Sizes??
By jevs in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 01-14-2011, 03:35 AM -
Is Dynatorch a good choice for mass production work?
By Homer Simpson in forum DynaTorchReplies: 3Last Post: 11-05-2010, 02:49 AM -
4x4 dynatorch available
By redfarm in forum DynaTorchReplies: 1Last Post: 08-10-2010, 12:14 AM -
Work holding options to hold thin round work? .024, .046 etc
By KyleH2 in forum MetalWork DiscussionReplies: 0Last Post: 06-07-2010, 07:22 PM -
CNC for a/c duct liner
By WMACS in forum Open Source CNC Machine DesignsReplies: 0Last Post: 10-02-2007, 07:18 PM
Posting Permissions
