I'm looking for some assistance to get a Fryer MB-14 mill with Anilam 3300 controller networked for a friend. The network chip on the SBC is the RL8139 series. CPU on the SBC is a 233 MHz.
Vender installed the necessary hardware and I have the machine networked and mapping a drive to a XP machine. To do this, I took out the P3M commands that start the CNC program while getting the network client for DOS installed.
Now that the networking stuff is good I put back the commands to start the P3M program in the AUTOEXEC.BAT and I get an error regarding TNT-DOS extender or something. Sorry, not by the machine at the momemnt.
I believe the issue is either the version of DOS (ROM-DOS instead of MS-DOS) or memory management.
Would someone post their CONFIG.SYS and AUTOEXEC.BAT files so I could compare to what we have and see if that is the issue?
I greatly appreciate any assistance!!!