585,753 active members*
3,776 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > Hitachi seiki Hitec turn Ht 20/25
Results 1 to 3 of 3
  1. #1
    Join Date
    Feb 2006
    Posts
    213

    Hitachi seiki Hitec turn Ht 20/25

    I have a Hitachi seiki Hitec turn Ht-20/25 equipped with Fanuc 3t along with Seicos controller.
    Presently I am getting SERVO ALARM 01 (OVERLOAD)
    I had found that SEICOS controller's Battery got exhausted. I have replaced the battery with new one and got rid from seicos battery alarm, but servo alarm is still being appeared on the screen.
    Kindly help me to solve this problem.

  2. #2
    Join Date
    May 2013
    Posts
    128
    check the x axis servo pulsecoder and motor

  3. #3
    Join Date
    Aug 2007
    Posts
    793
    if there is black or yellow cap servo motors, then check thermo (overload) relay close to servo drive
    but most likely thermo relay is the result, the cause lays in servo motor or in mechanics
    if in servo motor you may just clean it up (the carbon dust in collector may cause this alarm)

Similar Threads

  1. Hitachi Seiki Hitec-Turn / 1217 & 1220
    By j455 in forum DNC Problems and Solutions
    Replies: 1
    Last Post: 03-29-2012, 12:13 PM
  2. Tailstock Advance on Hitachi Seiki Hi Tec-Turn 23SIII
    By Bob Dolan in forum Mori Seiki lathes
    Replies: 2
    Last Post: 05-10-2011, 04:51 PM
  3. Did Mori Seiki Buy Hitachi Seiki?
    By Billet Sean in forum Mori Seiki lathes
    Replies: 6
    Last Post: 05-05-2011, 04:12 AM
  4. Fanuc 10T 1985 Hitec-turn 25 lathe
    By dave400 in forum Fanuc
    Replies: 3
    Last Post: 10-03-2010, 12:58 AM
  5. Hitachi Seiki
    By cre8tunes in forum Community Club House
    Replies: 0
    Last Post: 11-18-2006, 02:40 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •