For the RF-45 go ahead and run the 25mm. It will last longer.
For the RF-45 go ahead and run the 25mm. It will last longer.
youtube videos of the G0704 under the name arizonavideo99
Dear 109jb.
Many thanks for yours and everybody's advice much appreciated.
All I got to do is collate them all. work out the lengths.
Then find a supplier as I live in North Scotland.
Best wishes.
Yours Mechan6
Dear dazp1976,
Thank you for your advice.
As regards using the 1605DFU ballscrews.
Not heard of that classification, but will look it up.
I was thinking of using Two RK12 End support pre-loaded angular contact bearings on each end of the X Axis.
As one end is motor driven other has a the handwheel.
Thanks again, Best wishes.
Mechan6
Dear Stigoe,
many thanks for the advice concerning the 2005 Ballascrew for the Z axis .
My thoughts are inclining that way
As I live in N Scotland , got to find a supplier to suit.
Many thanks again.
Yours Mechan6
Dear shooter 123456.
Many thanks for the advice regarding the 2005 and the Z axis ballscrew.
And for taking the time to pull out the spec sheets, do the maths.
As I live in N Scotland. Will now collate all advice, measure & draw up then find a supplier.
Many thanks again.
Yours
Mechan6
Dear Stigoe,
Many thanks for the supplier information.
Will try them.
Best wishes.
Yours
Mechan6