Thanks BLoke!
It really helped me out.
now the Direction is Ok.
one request more If you could provide me the DIP switches settings and Magic Codes applied on it. is there any possibility to shift it to a DOS based OLD 386 or 486 Computer
Thanks BLoke!
It really helped me out.
now the Direction is Ok.
one request more If you could provide me the DIP switches settings and Magic Codes applied on it. is there any possibility to shift it to a DOS based OLD 386 or 486 Computer
Magic codes? What are these?
Do you mean making the machine software run on a PC?
yes MAgic Codes = Enter ***** enter ( for me these are Magic Codes )
yes is there any possibility to run the machine software in a PC
The codes you have used are the only ones that apply to your machine. There are more for machines with toolchangers and leadscrew maps but they are bedmills.
It's not possible to run the machine software on a PC. There was a version of it available many years ago but it needed a dongle.
Any Way Thank you very Much For your Helpful Assistance
hope to see you cooperation in future too.
Nice to meet you here.
best regards
Max
hi, I have New problem now.
when I switch on the Machine, when I press the power button from the console it does not start the Machine.
only DS1 and DS4 relay LED light blinks slightly on the relay board when press the button
please guide what should I check and do.
best regards
Max
Check the white plastic ribbon cable from the buttons to the front board in the console. It may have a bad track.
its not working man, have check the cable its okay. is there any thing else
Next, check the air pressure switch round the back. Then check the overloads on the contactors.
I have Checked the Air Pressure Switch, Its working Fine.
Where is Overload ??
On the contactors in the left hand cabinet.
hi, I don't Know what Happened but It is working now. today when I switched On the power its working.
any ways Thanks for the Help. But I am Still Curious that what is problematic on it
My machine is again having the same problem, the power button is not working again.
may be there is a possibility that air is comming but, the air pressure switch is not working. how can i check that , where is that Air pressure Switch
Bloke! I will really greatful pls help me out in this regard.
i have checked the power ratings of the main power supply
the light Blue Wire from Right Hand side is not Giving the 24VDC out put.
can This be the main Problem for not starting the Machine
Rest all the Wires are giving out put
white ---> Ground
Red --Black ---110 AC
Brown -------->+12 VDC
Blue ---------->+24 VDC (no output )
Orange ------->-12 VDC
Gray ---------->Com
Gray ---------->Com
Gray ---------->Com
Yellow --------> +5 VDC
Yellow --------> +5 VDC
Any Help ?????
I took a Risk by removing the 24vdc wire and placing a temporary 24vdc 40Amp switching Power supply and than tryed it powering up it worked.
Now I will try to repair the 24vdc power Supply
Thanks for the Motivation of CNC Zone,
and Bloke, Coz you are the real Instructor for me in this Forum
Thanks Bloke
Now My Problem is That
May Y-Axix is Probleming, It shows Error on " Error Detected on Y "
I have changed the Y connector to X , Than the Error Shifted on X
I concluded that MAy be the Fault is in Motor Or Encoder
I Opened the Motor, And When I checked the Carbon Brushes were finished.
Now I am trying To Replace it Carbon Brushes.
Hope it will Resolve My Error
Any Suggestion Would be Highly Appriciated
Thanks And Regards
Max
now I have Changed the carbon Brush of the Y motor, when I Power on the Machine it shows the Servo Fault
Any Clue ???
Assistance will be Highly Appriciated