585,708 active members*
4,024 visitors online*
Register for free
Login

Thread: Fanuc 6T G01 command problem

Results 1 to 5 of 5
  1. 06-23-2011, 07:37 AM #1
    hell_pk
    hell_pk is offline Member
    Join Date
    Oct 2007
    Posts
    67

    Fanuc 6T G01 command problem

    Hi!
    A vertical machine with Fanuc 6T controller stopped executing G01 command. Does not give any alarm or error.
    Plz advice....
    Reply With Quote Reply With Quote
  2. 06-23-2011, 11:08 AM #2
    sinha_nsit
    sinha_nsit is offline Registered
    Join Date
    Feb 2006
    Posts
    1792
    You are possibly using feed per revolution mode with spindle at rest. Do you see continuous green light on CYCLE START lamp?

    Does G00 work?
    Reply With Quote Reply With Quote
  3. 06-23-2011, 11:51 AM #3
    hell_pk
    hell_pk is offline Member
    Join Date
    Oct 2007
    Posts
    67
    Other commands are running. Cycle start lamp is green.
    Reply With Quote Reply With Quote
  4. 06-24-2011, 06:04 AM #4
    hell_pk
    hell_pk is offline Member
    Join Date
    Oct 2007
    Posts
    67
    Quote Originally Posted by hell_pk View Post
    Other commands are running. Cycle start lamp is green.
    G00 is also working
    Reply With Quote Reply With Quote
  5. 06-24-2011, 09:07 AM #5
    sinha_nsit
    sinha_nsit is offline Registered
    Join Date
    Feb 2006
    Posts
    1792
    Try G01 with G98 and an F-word (feed per minute): G98 G01 F_;
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Fanuc 0M command to clear the spindle??
    By Otterpaw in forum Fanuc
    Replies: 3
    Last Post: 04-01-2011, 06:10 AM
  2. problem with ,C command
    By cncozz in forum G-Code Programing
    Replies: 12
    Last Post: 07-02-2008, 05:23 PM
  3. Problem with the G70 command
    By markus314 in forum G-Code Programing
    Replies: 25
    Last Post: 06-23-2008, 07:25 PM
  4. fanuc OT controller skipe M00 command
    By suresh patil in forum Fanuc
    Replies: 2
    Last Post: 08-03-2007, 02:15 AM
  5. fanuc servo motor moving without command
    By mtech in forum Uncategorised MetalWorking Machines
    Replies: 5
    Last Post: 06-17-2003, 02:39 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules