I am doing a 3.5" deep hole in 5/8" copper. When i go to od turn The barloader is alarming out ($5 overload). Is my tourqe setting too high? I can not figure it out and the material is very pricey.
I am doing a 3.5" deep hole in 5/8" copper. When i go to od turn The barloader is alarming out ($5 overload). Is my tourqe setting too high? I can not figure it out and the material is very pricey.
on the last few pecks the machine is making a wierd noise.
Are you using coolant through drills? It sioounds to me like you might be pushing the material back with the drill and causing an A7 overload, especially if its making a strange noise the last two pecks.
www.atmswiss.com
Figured it out. I did a g83 to 3" then for the rest i did a feed in feed out. Thanks though