Hello to every one. I am working on CNC Vertical machining center having Heidenhain contouring control iTNC 530.Its main computer is MC422B & control unit is CC422. I am facing problems with its HRD hard disk. Is it possible to configure PC with X27/X127 port of main computer to run Drive Diag software to determine its health without HRD hard disk?
Aslam
Thread: Heidenhain iTNC 530
Results 1 to 2 of 2
-
07-22-2011, 06:21 PM #1
Registered
- Join Date
- Jul 2009
- Posts
- 7
Heidenhain iTNC 530
-
02-19-2012, 08:18 AM #2
Member
- Join Date
- Nov 2008
- Posts
- 69
Hi!
No, it is not possible to test your HRD throug the RS-port.
To really test your HRD you need to take it out and test somewhere else.
(on TNC 426 there was a test rouitine)
What kind of problems you are having?
Jukka
Reply With QuoteSimilar Threads
-
heidenhain itnc 530 - Q parameters
By greenchair in forum CNC (Mill / Lathe) Control Software (NC)Replies: 4Last Post: 11-30-2014, 10:39 AM -
Heidenhain iTNC 530 question
By Brian Brown in forum CNC (Mill / Lathe) Control Software (NC)Replies: 1Last Post: 12-19-2010, 10:53 PM -
Heidenhain iTNC 530 Network Settings
By zephyrmachine in forum CNC (Mill / Lathe) Control Software (NC)Replies: 3Last Post: 09-04-2010, 04:55 AM -
TOS with iTNC 530 HEIDENHAIN
By SheldonB in forum CNC (Mill / Lathe) Control Software (NC)Replies: 1Last Post: 04-15-2009, 04:35 AM -
Heidenhain iTNC 530
By Thanya in forum CNC (Mill / Lathe) Control Software (NC)Replies: 2Last Post: 03-12-2007, 10:33 PM
Posting Permissions
