[MSFAB]

I was wondering if anybody new if there was a parameter to change so that machine stops when the proper part count is achieved. I looked through our manuals and there is no button on the control. I can change the required part count in settings but it continues to go after the part count is achieved.
Any Ideas.

thanks Marcus

[MSFAB]

finally got a hold of the guy that services our machine. I was using m55 then m30 at the end per the manual. But it needed to be m54 witch counts the part then m99. it alarms out when the part count is reached

cheers marcus

[jdman66]

anybody know how to change keep relays?

[dcoupar]

anybody know how to change keep relays?

If we're still talking 31i, don't quote me, but it's close to this.

MDI - SETTING - Parameter Write Enable.

System - > PMC - [PMC MAINT] - [KEEP RELAY]

Cursor down & over to the bit you want to change. Enter 0 or 1, then INPUT.

Turn off Parameter Write.

[jdman66]

yes, 31 i
I tried it but couldnt find PMC key.

[dcoupar]

yes, 31 i
I tried it but couldnt find PMC key.

Sorry, I don't have access to a 31i to get the exact sequence of keystrokes.

Attached are from the GE Fanuc 31i Maintenance Manual.

[jdman66]

thanks alot!