585,987 active members*
4,623 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > EnRoute > feed rate % rpm

Thread: feed rate % rpm

Results 1 to 2 of 2
  1. 08-24-2011, 04:22 PM #1
    jovanifive
    jovanifive is offline Registered
    Join Date
    Aug 2008
    Posts
    63

    feed rate % rpm

    hello
    good morning
    thanks for replying and sharing
    I have a question for you
    I want to make a sample
    a 3D texture
    I have a multicam 3000
    sample is 4x8ft
    and I have a bit Onsrud 52-280 of 1 / 4

    I have no experience in this type of cuts
    I can advise that speed and rpm parameters I can use
    Reply With Quote Reply With Quote
  2. 08-25-2011, 02:34 AM #2
    MCPservice
    MCPservice is offline Registered
    Join Date
    Jun 2010
    Posts
    463

    feed rate % rpm

    To create a 3-D texture you are going to have to change your bit to a ball nose bit, second what type of material are you going to be cutting for this sample texture.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Okuma mill feed rate jumps to rapid feed
    By easyguy97 in forum Okuma
    Replies: 6
    Last Post: 12-20-2009, 11:14 AM
  2. Feed rate Ovverride also Increases rapid rate.
    By Korellibopper in forum Machines running Mach Software
    Replies: 1
    Last Post: 01-31-2008, 12:37 AM
  3. Feed Rate and Spindle Rate for this cut?
    By DroopyPawn in forum MetalWork Discussion
    Replies: 20
    Last Post: 11-22-2007, 06:12 AM
  4. C & Z Feed rate
    By rfstar in forum G-Code Programing
    Replies: 7
    Last Post: 06-22-2005, 06:38 AM
  5. How can I up my feed rate ?
    By ynneb in forum DIY CNC Router Table Machines
    Replies: 7
    Last Post: 07-13-2004, 03:40 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules