Xavior
DO NOT ALTER that feed format, that affects every other F output in your post---put it back to 9
Look for
Code:
ptap$ #Canned Tap Cycle
pdrlcommonb
result = newfs(2, feed) #added ST
pcan1, pbld, n$, *sgdrlref, *sgdrill, pxout, pyout, pfzout, pcout,
prdrlout, *feed, strcantext, e$
pcom_movea
your post also had pmisc2$ for RIGID TAPPING
( you have been selecting the floating tap cycle for rigid tapping )
The fix was in the 1st tapping cycle where the Feed value needed to be given another format within that cycle. The RED section is what alters the format, and what I added to the ptap$ cycle from the pmisc2$ to make them identical to each other, plus the 2 was a 12 ( 4/4 place output for all units, now 4/3 places )
I had fixed your tapping F output to be the same format as the X Y Z outputs, they would "switch" depending on the metic/inch units selected