Hi there
I wonder if any one can help?
Last week my lathe started to flag up several random fault codes for no apparent reason.( eg syntax error/drives not ready etc)The CRT screen also started to operate abnormally both in scale and content until it eventually ceased to operate.
I'm not an expert and have carried out basic checks of fuses/supply etc and the only thing I observed was the led on the power supply board was not lit.
My other 242 lathe is lit when normally operating.
This led did however briefly flash when I switched the power off( this is repeatable).
I bought a replacement service exchange power supply and this is doing exactly the same.???
Can anyone shine some light on this issue??
Cheers
Alex