Haas VF-2 Alarm 272 c-axis motor overheat.
Please let us know how to solve this problem. Thanks.
Haas VF-2 Alarm 272 c-axis motor overheat.
Please let us know how to solve this problem. Thanks.
A little more information would be helpful here.
When does it alarm?
What is the machine doing when it alarms?
Is it really overheating?
Is the fan running?
What have YOU done so far to help fix your problem?
bet its an amp... a pure guess but that's what its been on me every time i get a overheat.
thanks
Michael T.
"If you don't stand for something, chances are, you'll fall for anything!"
+1 "Need More Information"
What is the machine's serial number?
Is the alarm resettable immediately?
Once reset, how long until the machine alarms out?
Thanks,
Ken Foulks
Is the alarm resettable immediately? NOP !!!
When does it alarm? When set at c axis in program
What is the machine doing when it alarms? Stop & couldn't reset.
Is it really overheating? Nop !!!
Is the fan running? Yes
272 C-AXIS MOTOR OVERHEAT - Servo motor overheat. The temperature sensor in the motor indicates over 150° F. This can be caused by an extended overload of the motor such as leaving the slide at the stops for several minutes.
The thermal sensor in the motor is indicating that is open. Either the sensor is bad, parameter 176 bit 14 could be set to a 0, or maybe a cable is not sending to the mocon. In any case it is better to contact the local dealer for assistance in solving this issue.
Thanks,
Ken Foulks
What is "C" axis on a VF2??? My machine uses "A" axis... I've even heard of "B" axis but what is "C" Axis on a vertical mill?
I believe the C axis is the tool holder so probably the rotation motor but I've always had problems with the in and out motor.....or if its a sidemount disregard what i say.
thanks
Michael T.
"If you don't stand for something, chances are, you'll fall for anything!"