I am self taught in Mastercam X2 and I only work in wire frame just in case that information is needed.
Anyway, the Question.
Is there a way to set multiple work offsets in Mastercam and have all my drawing on one file? Typically when I do a set-up, it will run multiple ops in one cycle so we can pull a finished part every cycle. Right now I am programing ever op individually, proving it out, and then going back and meshing the code together by hand to eliminate redundant tool changes and for example, have tool 1 run across all 3 or 4 vises with unique offsets, then tool 2 running on all ops that it is required, etc. instead of running tools 1-5 on one op, then re calling up tools 1,3 and 4 on the next op for example.
I figure there has got to be an easier way of doing this than copy and pasting bits of code from individual programs and doing a little editing in between. When dealing with 3 or 4 ops it really isn't that bad, but my current project has 8 and it is a bit time consuming.
Sorry if I didn't explain that very well. Let me know if you have any questions and I am looking forward to any responses.
Thanks for reading!
Garrett