586,013 active members*
3,911 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Mazak, Mitsubishi, Mazatrol > Original DNC cabling - Mazatrol CAM M2 on Mazak VQC20/50

Thread: Original DNC cabling - Mazatrol CAM M2 on Mazak VQC20/50

Results 1 to 3 of 3
  1. 10-20-2011, 12:02 PM #1
    eltorio
    eltorio is offline Registered
    Join Date
    Oct 2011
    Posts
    0

    Original DNC cabling - Mazatrol CAM M2 on Mazak VQC20/50

    Dear All,

    On my new VQC20/50, the original DB25 female DNC plug has been replaced by a RJ45 one.

    Since there is no official standard for cabling EIA-232 on RJ45. Does someone know the original cabling for finding for the correct PC wire map?

    This are some picture of the plug (front view/ rear view and sticker showing wich card are used)

    Also what is the switch -wires SDC1 or SOC1- on the top right of the door?
    Reply With Quote Reply With Quote
  2. 10-20-2011, 01:01 PM #2
    txcncman
    txcncman is offline Gold Member
    Send a message via Yahoo to txcncman
    Join Date
    May 2004
    Posts
    4519
    Am I mistaken, or is the original wiring for the DB25 plug still in place?
    Reply With Quote Reply With Quote
  3. 10-20-2011, 01:13 PM #3
    eltorio
    eltorio is offline Registered
    Join Date
    Oct 2011
    Posts
    0
    Quote Originally Posted by txcncman View Post
    Am I mistaken, or is the original wiring for the DB25 plug still in place?
    You may have right I zoomed on my picture (wich is at least 3x more clear that in the machine) it seems to have 2 spacers, perhaps it is only an adapter screwed on the original DB25...

    Tomorrow I'll disassemble
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mazak M-4 Mazatrol T2 and mazatrol Cam T2 operating manual in english
    By tuanpq in forum Mazak, Mitsubishi, Mazatrol
    Replies: 31
    Last Post: 07-09-2021, 04:06 PM
  2. Mazak VQC20/40B Mazatrol Cam M-2. Alarm 22 and 23 batterie low, parameters wrong.
    By sve0019 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 3
    Last Post: 07-19-2017, 09:16 AM
  3. Mazak QT 15 with Mazatrol CAM T-2
    By cncren in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 02-23-2012, 01:06 PM
  4. Mazatrol T1 - Mazak
    By valvulin in forum Spanish
    Replies: 0
    Last Post: 10-31-2008, 10:17 PM
  5. Mazak, Mazatrol T1
    By valvulin in forum Spanish
    Replies: 1
    Last Post: 10-10-2008, 06:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules