hi,
I have a CNC Machine of FANUC MV-series 106A.
when I try to give any input to position it says " Write Protected "
can any one pls guide me to remove this error
thanks
nuzmeed
hi,
I have a CNC Machine of FANUC MV-series 106A.
when I try to give any input to position it says " Write Protected "
can any one pls guide me to remove this error
thanks
nuzmeed
usually there is a key in a lock on the panel to enable writing to the memory.
turn it to the write-enable position.......
the Edit LOCK key is in ON position
make it OFF
hi, the problem is resolved. actually the connection of EDIT KEY Lock was loose from Inside. I have fixed it.
thanks for the Support Guys