I upgraded to the latest version today and now my y axis is not running normal it kind of sputters and does not move at the normal speed. All settings are the same as the old version and X A Z axis are working normally.
When it installed it did the parallel driver, could that cause this or do you think this is a driver board issue?
I checked and the stepper is fine, the board is a TB6560.
Any ideas how to un install the parallel driver that was included with the software?
The old version of Mach does not communicate with the driver board anymore...
Time for a G540? :violin:
Results 1 to 2 of 2
-
11-05-2011, 09:21 PM #1
Registered
- Join Date
- Jul 2011
- Posts
- 86
Upgraded to latest version, y axis strange behavior
-
11-06-2011, 02:14 AM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
I believe the manual tells you how to uninstall the driver. Then just re-install the older version.Any ideas how to un install the parallel driver that was included with the software?Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
Strange behavior with VFD
By BanduraMaker in forum Gecko DrivesReplies: 3Last Post: 11-15-2011, 03:00 PM -
NM-200 - strange behavior?
By kvom in forum NovakonReplies: 1Last Post: 07-29-2011, 12:14 AM -
NM-200 - strange behavior?
By kvom in forum NovakonReplies: 3Last Post: 05-24-2011, 02:28 PM -
Strange Behavior.
By riveracnc in forum Mach Software (ArtSoft software)Replies: 2Last Post: 11-29-2008, 01:54 AM -
Milltronics strange behavior
By KBHone in forum MilltronicsReplies: 1Last Post: 12-10-2007, 12:00 AM
Posting Permissions
