I dont think I read anywhere on the manual addressing whether or not it is ok to crank the handwheel when everything is plugged in (but power off to the G540).
Is it ok or do you have to unplug everything or maybe short the resistor if it allows easy changing?
Or can you just crank away?
Results 1 to 2 of 2
-
11-06-2011, 10:43 AM #1
Registered
- Join Date
- Oct 2011
- Posts
- 0
Back EMF problem for G540? (manual cranking handwheel)
-
11-08-2011, 03:02 AM #2
Gold Member
- Join Date
- Mar 2003
- Posts
- 2839
Feel free to crank away. Cranking will be easier if you power-up the G540 and have it in E-Stop (red LED). That way your muscles don't have to run the cranked motor as a generator.
Mariss
Reply With QuoteSimilar Threads
-
G540 Updated Manual
By CoAMarcus in forum Gecko DrivesReplies: 5Last Post: 03-14-2017, 04:51 PM -
Relay with G540 and a manual switch? 2nd try
By Fastest1 in forum Gecko DrivesReplies: 4Last Post: 02-27-2010, 11:22 PM -
My Upside down back to front problem
By Cosha in forum Mach Software (ArtSoft software)Replies: 0Last Post: 03-03-2009, 09:32 PM -
Problem: Feed back on Screen from Spindle
By northstarr in forum Haas MillsReplies: 2Last Post: 06-28-2008, 03:02 PM -
Cranking out part's on Benchtop Mills
By Ron111 in forum Benchtop MachinesReplies: 4Last Post: 06-09-2007, 05:39 PM
Posting Permissions
