I have two questions with reards to the 2110 mother board and the 2020 drive cards.
The mother board has slots for four axis.The slots are numbered 1 thru 4. Are these slots axis specific such as slot 1 = A, 2= Z etc. Or do you just hook up and define in your software (Mach 2)?

The second question concerns the motor hookup to the 2020 card. Polarity for power in is specified on the card but the motor connections are not . Do i have to be concerned or do I configure thru the software?

Anybody been down this way yet?

Tnak you
John D.